Which type of cable is most likely in use with RJ-45 connectors attached to a computer?
- 10Base2
- 10Base5
- 10BaseT
- 10BaseXL
What device must be installed on a computer to provide it with a physical and electrical connection to a network?
- NIC
- Router
- Gateway
- BNC connector
Which memory address range is reserved for VGA video card?
- C000-C3FF
- C000-C7FF
- D000-D7FF
- D000-DFFF
What can a crossover cable in an Ethernet network be used to do?
- Test a faulty network card.
- Connect two network devices without a Hub
- Improve bandwidth between the server and the workstations
- Convert from 10 Megabits per second to 100 Megabits per second
On a dot matrix printer which paper type requires tractors to feed the paper?
- Envelopes
- Fiction Fed
- Single sheets
- Continuous Forms
Why would the back of your page come out dirty on a Laser printer?
- Light weight paper
- High humidity level.
- Contaminated fuser.
- Bad AC power module
Where is hard disk information stored?
- RAM
- CMOS
- BOOT.INI
- SYSTEM.INI
Which motherboard type allows you to turn off the computer via software?
- AT
- ATX
- MCA
- VESA
What should you do after installing a new ink-jet cartridge?
- Reboot your computer
- Print a very detailed picture
- Adjust the assignment manually
- Run the printer alignment program
How many pins are on a serial port connector? (Choose two)
- 8
- 9
- 15
- 25
Why can multiple SCSI devices work on the same channel?
- No two devices are made exactly the same.
- Each manufacturer codes its equipment number.
- Each can be configured with a unique identification number.
- The first device is set as master and others are set slave.
A Windows 9x system fails to successfully detect new devices that are added. What should you check first?
- Device manager for DMA assignments.
- Plug and Play settings in control panel.
- CMOS settings in BIOS for Plug and Play
- BIOS settings in CMOS for Plug and Play.
How many bits wide is the AGP Bus?
- 8
- 16
- 32
- 64
On the dot-matrix you only see the bottom half of the characters. What is a possible cause of this?
- Defective print head
- Wrong paper thickness
- Paper text incorrectly on tractor.
- Defective home position sensor.
How many IDE controllers are typically built into an ATX motherboard?
- 1
- 2
- 4
- 8